Fuel Tank - Terex PT-100G Forestry Service Manual

Compact Track Loader
7. Chassis and Fuel Tank
Remove Screws
7-2
5. Remove the screws that secure the fuel sending
unit to the tank (fig. 7-2).
7-3
6. Remove the sending unit by pulling it through the
opening in the fuel tank (fig. 7-3).
-- Neg
+ Pos
7-4
Installation
1. To install the fuel sending unit, reverse the removal
procedure (See fig. 7-4 for terminal installation).

Fuel Tank

Removal
Required Tools
Screwdriver
Combination/Socket Wrench
1. Raise and support the lift arms as described on
2. Tilt and support the operator enclosure (cab) as
3. Loosen the hose clamps that secure the return and
4. Disconnect and plug the ends of the hoses to
Install First
5. Carefully remove the zip tie from the fuel sending
Install Last
6. Loosen the hose clamp securing the main fuel line
7-2
page 4-1 of this manual.
described on page 4-2 of this manual.
Vent
7-5
vent hoses to the left and right, rear of the fuel
tank (fig. 7-5).
prevent fuel leakage.
7-6
unit harness and then unplug from the main wire
harness (fig. 7-6).
to the tank outlet in the front, right corner of the
tank. Disconnect and then plug the line and cap
the outlet to prevent fuel leakage (fig. 7-7).
Vent
Vent
Return