Terex PT-100G Forestry Service Manual page 90

Compact Track Loader
13. Undercarriage
13-46
22. Press the outer bearing race into the hub with tool
# 0403-330 until it seats (fig. 13-46).
13-47
23. Pack the bearing with Terex Multi-Purpose EP
Lithium Grease and then install it onto the bearing
sleeve using tool 0403-333 (fig. 13-47).
24. Press it into the assembly until it gently seats into
the bearing race (fig. 13-47).
13-48
25. If necessary, use a needle dispenser to fill any
places in the bearing that are not full of grease to
ensure adequate lubrication (fig. 13-48).
Part #: 0403-330
13-49
26. Remove the allen plug in the center portion of the
hub (fig. 13-49).
Part #: 0403-333
13-50
27. Add 2 oz. of 10W-30 (API CH-4) engine oil to the
hub as shown, then reinstall the plug and tighten
(fig. 13-50).
13-51
28. The hub assembly is now ready to be reinstalled.
To install it onto the machine, reverse steps 1-3 on
page 13-7 of this procedure. Make sure to read
the note below step 3 prior to reinstalling
(fig. 13-51).
29. Repeat this procedure throughout the
undercarriage as necessary to repair worn or
damaged components and restore proper function.
13-10