Removal Procedure; Dash Pod Covers - Terex PT-100G Forestry Service Manual

Compact Track Loader
6. Operator Enclosure
6-2
2. Remove the retaining clip from each of the gas
springs using a small screwdriver (6-2).
6-3
3. Remove the gas spring by pulling both ends
off of from the ball joints (6-3).
Installation
1. To reinstall the lap bar gas assist springs, reverse
the removal procedure.

Dash Pod Covers

Removal
Required Tools
Phillips Screwdriver
6-4
1. Remove the fasteners securing the dash pod
covers to the pod base (fig. 6-4).
6-5
2. Pivot the cover away from the pod base to
expose the connectors. Disconnect the switches
and display from the cab harness, then remove
the cover (fig. 6-5).
Note: The connectors on the harness are labeled as
are the wires in the cover. Use these labels to properly
identify (match up) and reconnect the harness to the
instruments during installation.
Note: At this point in the disassembly process, the
instruments mounted to the cover may be removed
and replaced if needed.
Installation
1. To reinstall either cover, reverse the steps of the

removal procedure.

6-2