Terex PT-100G Forestry Service Manual page 85

13-18
17. Apply red (high strength) thread locking compound
to the wheel retaining bolt as shown (fig. 13-18).
13-19
18. Install the bolt and tighten it (fig. 13-19).
19. If you haven't already, repeat steps 10-18 of this
procedure on the other side of the hub/wheel
assembly to secure the second wheel in place.
13-20
20. Once the hub/wheel assembly is together as
shown, torque the wheel retaining bolts to 180 ft.
lbs. / 244 Nm to secure them in place (fig. 13-20).
13-21
13-22
21. Remove the allen plug from the center of the hub
assembly and fill it with 2 ounces of 10W-30 API
CH-4 engine oil. Then reinstall the plug (fig. 13-
21, 13-22).
22. Repeat this procedure on the other half of the
bogie assembly if necessary prior to installing the
two halves back onto the undercarriage.
13-23
23. Place the rubber rods back into position on the
square shaft, then tape them in place to keep
them secure while installing the bogie assemblies
around them (fig. 13-23).
24. Reverse steps 1-3 of this procedure to reinstall the
bogie assembly back onto the undercarriage and
complete the procedure.
25. Repeat this procedure as necessary throughout
the undercarriage to restore proper function.
13-5
Compact Track Loader
13. Undercarriage