Removal Procedure; Pivot Pin - Terex PT-100G Forestry Service Manual

Pivot Pin (quick attach)
Removal
Required Tools
Combination/Open End/Socket Wrenches
Terex Approved Jack Stand (or equivalent)
Hammer
Punch (brass)
15-8
1. Rest the lift arms on an Terex approved jack stand
to provide clearance for quick attach disassembly.
(fig. 15-8)
Remove bolt & nut
15-9
2. Remove the bolt securing the pivot pin to the quick
attach weldment, then drive the pin out with a
hammer and brass drift punch. (fig. 15-9)
Note: There are four pivot pins that connect the quick
attach to the lift arm and cylinders. All four pins are
removed in a similar manner.
Installation
1. To install the quick attach pivot pins, reverse the

removal procedure.

2. Repeat this process as necessary to remove and
replace worn or damaged quick attach pins.
Drive out
15-3
Compact Track Loader
15. Quick Attach