Terex PT-100G Forestry Service Manual page 96

Track Loader
Compact
14. Lift-Arm Components
14-10
4. Remove the bolt securing the lower pin to the
quick attach. (fig. 14-10)
14-11
5. Remove the bolt securing the upper pin to the lift
arm weldment. (fig. 14-11)
Disconnect
14-12
6. Disconnect the outer quick attach cylinder hose (if
equipped) to allow the lower pin to be removed.
(fig. 14-12)
14-13
7. Use a pry bar to slide the lower pin out of the cylin-
der end allowing it to be removed. (fig. 14-13)
14-14
8. Use a pry bar to pry the lower cylinder eyelet out
of the upper Q/A mount as shown. (fig. 14-14)
14-15
9. Use a hammer and a brass punch to tap the upper
pin most of the way out of the lift arm weldment.
(fig. 14-15)
Note: Make sure to support the cylinder (have an
assistant support it if necessary) while removing the
upper pin to prevent it from falling and being damaged
or from causing injury to anyone standing underneath.
14-4