Removal Procedure; Installation Procedure; Suction Screen - Terex PT-100G Forestry Service Manual

22. Carefully remove hydraulic tank from chassis by
lifting up and sliding it towards the back of the
machine (fig 9-17).
Installation
1. To install the hydraulic reservoir, reverse the

removal procedure.

Note: The only service issue warranting the removal of
the reservoir is hydraulic system contamination. Upon
installation, the tank must be clean and free of any dirt
or debris that may contaminate the hydraulic oil. If you
are unable to successfully flush the tank clean of all
dirt or debris, replace the tank.

Suction Screen

Removal
Required Tools
Small Pry Bar (hose removal if necessary)
Socket Wrench & Extension
Combination Wrenches (to remove lines)
Note: The suction screen may be removed with the
reservoir tank still in the machine. If this is necessary,
remove the center belly pan and tilt and support the
cab to gain access.
Flange
9-18
(fig. 9-18)
Suction screen
Bolts / Washers
1. If the tank is still in the machine, drain the
hydraulic fluid as described on page 4-14 of this
manual.
2. Remove/disconnect any tubes/hoses connected to
the flange weldment that may interfere with
removal.
3. Remove the bolts and washers (12) securing the
flange to the hydraulic reservoir.
4. Slide the assembly out of the reservoir as shown.
5. The suction screen is now accessible for
inspection or replacement.
Note: If removal is necessary, thread the suction
screen off of the flange weldment and remove.
Installation
1. To install the suction screen, reverse the removal
procedure.
Note: It is important to inspect the screen for pieces of
metal or other debris that may have been generated by
a worn or defective component. If there is debris
present on the screen, the hydraulic system (including
the reservoir) must be flushed clean to remove any
and all contamination (debris). The screen should be
replaced as well as any components found to be
defective.
o-ring
9-5
Compact Track Loader Loader
9. Hydraulic reservoir