Terex PT-100G Forestry Service Manual page 78

Compact Track Loader
12. Engine
12-22
8. Separate the return fuel line connector plug
located behind the oil dipstick on the ride side of
the engine (fig. 12-22).
ground terminal
12-23
9. Disconnect the battery cable, ground cables, and
other wires from the starter on the left side of
the engine compartment (fig. 12-23).
Disconnect
12-24
10. Disconnect the wire harness from the alternator
and the glow plug connector on the left side of the
engine compartment (fig. 12-24).
Fuel line
return
solenoid terminals
Glow plug
connector
12-6
Bolt
12-25
11. Disconnect the ECU wire harness connector from
the ECU (computer), located behind the oil dip
stick on the right side of the engine compartment
and then loosen the center bolt on the connector
to allow it to be unplugged (fig. 12-25).
Springs
12-26
12. Remove the lower three springs from exhaust pipe
and then remove the three bolts that secure the
pipe to the engine. Remove the pipe (fig. 12-26).
12-27
13. Loosen the hose clamp on the air intake located
on the left side of the engine and right tower
(fig. 12-27).
ECU wire
harness