Terex PT-100G Forestry Service Manual page 64

Compact Track Loader
10. Lift-Arm/Drive Controls
1. Relax all hydraulic actuators to relieve pressure in
the hydraulic system prior to service.
2. Turn the ignition switch to the OFF position,
remove the key and disconnect the battery to
avoid accidental start.
3. Perform the interior front side panel removal
procedure that addresses the joystick you plan to
remove in page 6-3 of this manual.
10-1
10-2
4. Expose and cut the zip tie securing the lower
portion of the boot to the joystick body, then lift it
upwards (figure 10-2).
10-3
5. Remove the four bolts to disconnect the joystick
from the mount (fig. 10-3).
10-4
6. Disconnect wire harness from joystick (fig 10-4).
10-5
7. Lift the joystick through the opening in the bracket
and remove it from the machine (fig. 10-5).
Remove (optional)
10-6
8. Remove the bolts (3) securing the joystick mount-
ing bracket to the cab from the outside (fig. 10-6).
(optional)
Installation
1. To install the joystick, reverse the removal
procedure.
10-2