Installation Procedure; Side Panels; Pillar Harness Panel - Terex PT-100G Forestry Service Manual

Side Panels

Removal
Required Tools
Phillips Type Screwdriver
6-6
1. Remove the fasteners securing the forward portion
of the side panel to the cab enclosure (fig. 6-6).
6-7
2. Pull the side panel away from the cab as shown,
then remove it from the machine (fig. 6-7).
6-8
3. Remove the fasteners securing the rear portion of
the side panel to the cab enclosure (fig. 6-8).
Power Outlet
6-9
4. If removing the left side panel, disconnect the 12v
power outlet, then remove the panel from the
machine (fig. 6-9).
Installation
1. To install the side panels, reverse the removal
procedure.
Pillar Harness Panels
Removal
6-10
1. Remove the fasteners securing the pillar panel
to the cab enclosure (fig. 6-10).
6-11
2. Pivot the panel away from the cab to expose the
wire harness. (Disconnect alarm if removing the
left pillar harness panel) (fig. 6-11).
Installation
1. To install the pillar panels, reverse the removal
procedure.
6-3
Compact Track Loader
6. Operator Enclosure