Installation Procedure; Seat; Headliner - Terex PT-100G Forestry Service Manual

Compact Track Loader
6. Operator Enclosure

Seat

Removal
Required Tools
Combination/Socket Wrench
1. Raise and secure the cab as described on page
4-2 of this manual.
6-12
2. Remove the four nuts securing the seat to the cab
floor (fig. 6-12).
6-13
3. Lift and move the seat forward slightly to expose
the seat switch harness located behind the seat
(fig. 6-13).
6-14
4. Disconnect the harness, then remove the seat
from the machine (fig. 6-14).
Installation
1. To install the seat, reverse the removal procedure.

Headliner

Removal
Required Tools
Phillips/Blade Type Screwdrivers
1. Remove the finishing caps with a blade type
screwdriver to gain access to screws as shown
(fig. 6-14).
6-15
2. Remove all screws with a phillips screwdriver
(fig.6-15).
6-16
3. Lower the headliner slightly, then disconnect the
dome light from the cab harness. Once discon-
nected, you may remove the headliner from the
cab (fig. 6-16).
Installation
1. To install the headliner panel, reverse the removal
procedure.
6-4