Sensor (Fuser Output) Lingering Jam Service Check - Dell 5535dn Service Manual

Step
6 Check the above sensor for proper connection.
Is the above sensor connected properly?
7 Check the aligner assembly for obstructions.
Is the above component free from obstructions?
8 Check the transfer roll assembly for damage.
Is the above component free from damage?
9 Perform a print test and check the main motor assembly.
Is the media properly transported and able to reach the
sensor (fuser output)?
10 Perform a print test.
Does the problem remain?

Sensor (fuser output) lingering jam service check

Use this procedure for the following jams:
• 202.01
• 202.12
• 202.35
• 202.57
• 202.76
• 202.86
Step
1 Check the media size setup and tray guides for all media
trays.
Does the media size, in use, match the size set for all media
trays?
2 Check all the media trays for proper media installation.
Is the media properly installed in all the media trays?
3 Check the door assembly, rear.
Is the above component properly closed?
Check
• 202.02 • 202.07
• 202.26 • 202.27
• 202.36 • 202.37
• 202.59 • 202.60
• 202.77 • 202.82
• 202.87
Check
Yes
Replace the fuser Replace the
unit assembly. connection.
Go to "Fuser unit
assembly
removal" on
page 4-15.
Go to step 8. Remove
obstructions.
Go to step 9. Replace the
transfer roll
assembly.
Go to "Transfer
roll assembly
removal" on
page 4-56.
Go to step 10. Replace the main
drive motor
assembly.
Go to "Main drive
motor assembly
removal" on
page 4-20.
Contact next Problem solved.
highest level of
tech support.
• 202.10 • 202.11
• 202.32 • 202.34
• 202.51 • 202.52
• 202.61 • 202.62
• 202.84 • 202.85
Yes
Go to step 2. Replace the
media, or change
the media size
setup.
Go to step 3. Remove and
properly re-install
the media.
Go to step 4. Open then
properly close the
door assembly,
rear.
Diagnostic information
No
No
2-133