Sensor (Narrow Media) Static Jam Service Check - Dell 5535dn Service Manual

Step
5 Check the sensor (narrow media) for proper operation.
1. Enter the diagnostic mode
2. Select Base sensor tests
3. Observe the line item "output"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
6 Check the above sensor for proper connection.
Is the above sensor connected properly?
7 Check the aligner assembly for obstructions.
Is the above component free from obstructions?
8 Check the transfer roll assembly for damage.
Is the above component free from damage?
9 Perform a print test and check the main motor assembly.
Is the media properly transported and able to reach the
sensor (fuser output)?
10 Perform a print test.
Does the problem remain?

Sensor (narrow media) static jam service check

Use this procedure for the following jams:
• 202.03
• 202.63
Ste
p
1 Check the media path for partially fed or jammed media.
Is the media path free from partially fed or jammed media?
2-136
Service Manual
Check
• 202.13 • 202.28
• 202.78 • 202.88
Check
Yes
Go to step 7. Go to step 6.
Replace the fuser Replace the
unit assembly. connection.
Go to "Fuser unit
assembly
removal" on
page 4-15.
Go to step 8. Remove
obstructions.
Go to step 9. Replace the
transfer roll
assembly.
Go to "Transfer
roll assembly
removal" on
page 4-56.
Go to step 10. Replace the main
drive motor
assembly.
Go to "Main drive
motor assembly
removal" on
page 4-20.
Contact next Problem solved.
highest level of
tech support.
• 202.38 • 202.53
Yes
Go to step 2. Remove any pre-
staged or jammed
media.
No
No