Sensor (ADF media exit) fan bracket assembly removal (X654, X656, and X658)
1. Remove the ADF cover, front. See "ADF cover, front removal" on page 4-64.
2. Remove the ADF rear cover. See "ADF cover, rear removal" on page 4-65.
3. Open the ADF top door assembly.
4. Disconnect the ground strap, the fan (CN12) harness, and the media exit sensor (CN9) harness.
5. Remove the two screws (A) on the front and rear of the sensor (ADF media exit) fan bracket assembly.
6. Remove screw (B) from the ground strap.
7. Remove the sensor (ADF media exit) fan bracket assembly.
Note: Remove the fan filter cover assembly from the used sensor (ADF media exit) fan bracket assembly, and
install on the new sensor (ADF media exit) fan bracket assembly.
Replacement note: Be sure to reinstall the ground strap.
4-76
Service Manual