Dell 5535dn Service Manual page 77

Error
code or Error contents
message
243.05 Sensor (pass through)
late jam
Source = Tray 3
243.06 Sensor (pass through)
late jam
Source = Tray 3
243.08 Sensor (pass through)
lingering jam
Source = Tray 3
243.10 Sensor (pass through)
late jam
Source = Tray 3
243.13 Sensor (pass through)
static jam
Source = Tray 3
243.16 Sensor (pass through)
late jam
Source = Tray 3
243.17 Media tray pulled jam
Source = Tray 3
243.18 Pick retry timeout
Source = Tray 3
243.19 Pick retry timeout
Source = Tray 3
243.33 Tray 3 not ready
Source = Tray 3
Description/Action
The media is late reaching the
sensor (pass through) within
the specified time.
The media is late reaching the
sensor (pass through) within
the specified time.
Media reached the sensor
(pass through) within the
specified time but did not clear
it within the specified time.
The media is late reaching the
sensor (pass through) within
the specified time.
Media remains on the sensor
(input) during the warm up
sequence.
The media is late reaching the
sensor (pass through) within
the specified time.
A media tray above the source
tray was pulled during the
printing process.
The engine timed out waiting
for the tray 3 to report ready
before the first pick attempt.
The engine timed out waiting
for the tray 3 to report ready
before a pick retry attempt.
Tray was not properly pushed
into the machine.
Possible repair actions
Go to sensor (pass through)
late jam service check.
See "Sensor (pass through)
late jam service check" on
page 2-141.
Go to sensor (pass through)
late jam service check.
See "Sensor (pass through)
late jam service check" on
page 2-141.
Go to sensor (pass through)
lingering jam service check.
See "Sensor (pass through)
lingering jam service check"
on page 2-142.
Go to sensor (pass through)
late jam service check.
See "Sensor (pass through)
late jam service check" on
page 2-141.
Go to sensor (pass through)
static jam service check.
See "Sensor (pass through)
static jam service check" on
page 2-143.
Go to sensor (pass through)
late jam service check.
See "Sensor (pass through)
late jam service check" on
page 2-141.
1. Remove all media present
in media path.
2. Close all media trays.
Turn the machine off/on.
Turn the machine off/on.
1. Check the size sensing
fingers on the media tray
for damage
2. Replace the media tray
assembly if problem
remains.
3. Check the switch (media
size) for proper connection.
4. Replace the switch (media
size) if problem remains.
Go to "Switch (media
size) assembly removal"
on page 4-45.
Diagnostic information
2-45