Skew (Using Adf) - Dell 5535dn Service Manual

Skew (using ADF)

Leading edge
Trailing edge
The printed image is not paralleled with both sides of the media.
Step
1 Check printer installation placement.
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
2 Properly load document into the ADF unit assembly and
ensure all guides are set correctly.
Re-print the defective image.
Does the error continue?
3 Check for obstructions in the area of the media feed
path in the ADF.
Is the media feed path free from any obstructions?
4 Is the ADF left cover assembly properly and evenly
closed.
5 Check the ADF/pick roll assembly for damage and
wear.
Is the ADF feed/pick roll assembly free from damage
and wear?
6 Check the ADF separator roll.
Is the ADF separator roll free from damage and wear?
2-176
Service Manual
Check Yes
Go to step 2. Correct the
installation
placement.
Go to step 3. Problem solved.
Go to step 4. Remove
obstructions.
Go to step 5. Open then
properly close
the ADF left
cover assembly.
Go to step 6. Replace the
ADF feed/pick
roll assembly.
Go to "ADF
feed / pick roll
assembly
removal" on
page 4-61.
Go to step 7. Replace the
ADF separation
roll.
Go to "ADF
separator roll
removal" on
page 4-62.
No