Sensor (Input) Late Jam Service Check - Dell 5535dn Service Manual

Sensor (input) late jam service check

Use this procedure for the following jams:
• 200.07
• 241.06
• 241.15
• 250.06
• 250.11
• 260.14
Step
Check the media size setup and tray guides for all media
1
trays.
Does the media size, in use, match the size set for all media
trays?
2 Check the media trays for overfilling.
Are any of the media trays overfilled?
3 Check the media condition in all media trays.
Is any of the media in any of the media trays crumpled or
damaged?
4 Check the media tray pass through areas for obstructions.
Are the pass through areas in all the media trays free from
obstructions?
5 Check media origination.
Did the media originate from the MPF?
6 Check the MPF pick roll assembly.
Is the above component free of excess wear and
contamination?
7 Perform a MPF print test and check the MPF pick solenoid
for proper operation.
Does the above component operate properly?
8 Check media origination.
Did the media originate from the internal duplex?
9 Check the internal duplex media path for obstructions.
Is the above component free from obstructions?
• 230.04 • 230.06
• 214.10 • 241.11
• 241.16 • 241.18
• 250.07 • 250.08
• 260.07 • 260.10
• 260.15 • 260.16
Check
• 237.00 • 239.11
• 241.12 • 241.14
• 242.09 • 250.03
• 250.09 • 250.10
• 260.11 • 260.12
Yes
Go to step 2. Replace the
media, or change
the media size
setup.
Remove any Go to step 3
excess new
media.
Replace the Go to step 4.
damaged media
with new.
Go to step 5. Remove
obstructions.
Go to step 6. Go to step 8.
Go to step 7. Clean or replace
the MPF pick roll
assembly.
Go to "MPF
pick roll
assembly
removal" on
page 4-26.
Go to step 17. Replace the MPF
pick solenoid.
Go to "MPF pick
solenoid
assembly
removal" on
page 4-26.
Go to step 9 Go to step 13
Go to step 10 Remove
obstructions.
Diagnostic information
No
2-127