Dell 5535dn Service Manual page 107

Error
code or Error contents
message
290.03 Sensor (ADF sheet
through) lingering jam
290.10 Sensor (ADF 1st
scan) static jam
291.00 Sensor (ADF 2nd
scan) static jam
291.01 Sensor (ADF 2nd
scan) late jam
291.02 Sensor (ADF media
exit) late jam
292.00 ADF top door open
jam
293.00 Media missing jam
294.00 Sensor (ADF media
exit) static jam
294.01 Sensor (ADF media
exit) lingering jam
294.03 Sensor (ADF media
exit) lingering jam
840.01 Scanner manually
disabled
840.02 Scanner auto
disabled
841.xx Scanner image
pipeline failure
Description/Action
Media reached the sensor
(ADF sheet through) but did
not clear it within the specified
time.
Media remains on the sensor
(ADF 1st scan) during the
warm up sequence.
Media remains on the sensor
(ADF 2nd scan) during the
warm up sequence.
The media does not reach the
sensor (ADF 2nd scan) within
the specified time.
The media does not reach the
sensor (ADF media exit) within
the specified time.
The ADF top door assembly
was opened while the ADF was
operating.
The media is removed from the
ADF once the feed process is
initiated.
Media remains on the sensor
(ADF media exit) during the
warm up sequence.
Media reached the sensor
(ADF media exit) within the
specified time but did not clear
it within the specified time.
Media reached the sensor
(ADF media exit) within the
specified time but did not clear
it within the specified time.
The scanner has been
manually disabled
The scanner has automatically
been disabled by the controller
The scanner image ASIC has
failed
Possible repair actions
See "Sensor (ADF sheet
through) lingering jam
service check" on
page 2-115.
See "Sensor (1st scan) static
jam service check" on
page 2-117.
See "Sensor (2nd scan)
static jam service check" on
page 2-118.
See Go to "Sensor (ADF 2nd
scan) late jam service check"
on page 2-149.
See "Sensor (ADF media
exit) late jam service check"
on page 2-123.
See "ADF top door open jam
service check" on
page 2-121.
See "Media missing jam
service check" on
page 2-121.
See "Sensor (ADF media
exit) static jam service
check" on page 2-122.
See "Sensor (ADF media
exit) lingering jam service
check" on page 2-125.
See "Sensor (ADF media
exit) lingering jam service
check" on page 2-125.
Enter the configuration mode to
re-enable the scanner.
Enter the configuration mode to
re-enable the scanner.
1. Check all connections on the
ADF controller card assembly.
2. Replace the scanner
controller card assembly if
problem remains. Go to
"Scanner controller card
assembly removal (models
X651, X652/5535dn, X654,
and X656)" on page 4-132 or
"Scanner controller card
assembly removal (model
X658)" on page 4-129.
Diagnostic information
2-75