Sensor (Adf Media Exit) Bracket Assembly Removal (X) - Dell 5535dn Service Manual

4. Using a flat-blade screwdriver, press on the tab (A) securing the sensor (standard bin exit) actuator
assembly.
5. Position the sensor (standard bin exit) actuator assembly where the laser cover can be removed.
6. Remove the laser cover. See "Laser cover removal (model X658)" on page 4-104.
7. Remove the sensor (standard bin exit) actuator assembly.
Sensor (ADF media exit) bracket assembly removal (X651)
1. Remove the ADF cover, front. See "ADF cover, front removal" on page 4-64.
2. Remove the ADF rear cover. See "ADF cover, rear removal" on page 4-65.
3. Open the ADF top door assembly.
4. Disconnect the ground strap, the fan (CN12) harness, and the media exit sensor (CN9) harness.
5. Remove the two screws (A) on the front and rear of the sensor (ADF media exit) fan bracket assembly.
4-90
Service Manual