Dell 5535dn Service Manual page 155

3 Check the sensor (ADF media exit) for proper connection.
Is the above component properly connected?
4 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
5 Perform a print test using the ADF.
Does the problem remain?
Sensor (ADF media exit) late jam service check
Use this procedure for the following jams:
• 294.01
Step
1 Check the original document condition.
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes or excessive
wear?
2 Check the ADF rolls for wear.
Is the ADF feed/pick roll assembly or the ADF separation
roll guide assembly free of excess wear?
Check
Replace the Replace the
sensor (ADF connection.
media exit).
Go to "Sensor
(standard bin
exit) actuator
assembly
removal" on
page 4-89 or
"Sensor (ADF
media exit)
bracket
assembly
removal (X651)"
on page 4-90.
Replace the ADF Problem solved.
controller card
assembly.
Go to "ADF
controller card
removal" on
page 4-67.
Go to step 5.
Contact next Problem solved.
highest level of
tech support.
Yes
Go to step 2. Remove damaged
original document
and replace with a
new undamaged
original document.
Perform a ADF
test. If the problem
remains, go to
step 2.
Go to step 3. Clean or replace
the ADF feed/pick
roll assembly or
the ADF
separation roll
assembly.
Go to "ADF feed /
pick roll
assembly
removal" on
page 4-61 or
"ADF separator
torque limiter
assembly
removal" on
page 4-63.
Diagnostic information
No
2-123