Sensor (Adf Sheet Through) Lingering Jam Service Check - Dell 5535dn Service Manual

Step
4 Check the sensor (ADF 1st scan) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Observe the line "sensor (ADF 1st scan)"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
5 Check the sensor (ADF 1st scan) for proper connection.
Is the above component properly connected?
6 Check the ADF feed drive motor assembly for proper
connection.
Is the above component properly connected?
7 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
8 Perform a print test using the ADF.
Does the problem remain?

Sensor (ADF sheet through) lingering jam service check

Use this procedure for the following jams:
• 290.03
Step
1 Check the media size setup and tray guides for the ADF.
Does the media size, in use, match the size set for the ADF
Check
Check
Yes
Go to step 6. Go to step 5.
Replace the Replace the
sensor (ADF 1st connection.
scan).
Go to "Sensor
(ADF 1st scan)
removal" on
page 4-82.
Replace the ADF Replace the
feed drive motor connection.
assembly.
Go to "ADF feed
drive motor
assembly
removal" on
page 4-77.
Replace the ADF Problem solved.
controller card
assembly.
Go to "ADF
controller card
removal" on
page 4-67.
Go to step 8.
Contact next Problem solved.
highest level of
tech support.
Yes
Go to step 2. Replace the
media, or change
the media size
setup.
Diagnostic information
No
No
2-115