Mfp Stapler Assembly Sensor (Media In Stapler) Removal - Dell 5535dn Service Manual

MFP stapler assembly sensor (media in stapler) removal

1. Remove the stapler unit assembly from the . See "MFP stapler assembly stapler unit assembly
removal" on page 4-212.
2. Using a flat-blade screwdriver, release the tabs (A) securing the sensor.
A
3. Using needlenose pliers, carefully grip the sensor and pull it out and disconnect the harness.
Replacement Notes: Using needlenose pliers, place the rear most tab in the sensor bracket first. Then push
on the rear face of the sensor until the other two tabs snap into place.
4-219
Repair information