THORLABS DCU223x Operation Manual And Sdk page 512

DCx Cameras
Cameras & functions
XP (32 bit).
The is_WriteI2C() function has been extended with the
IS_I2C_DONT_WAIT parameter. The default polling may be
disabled, whether the byte has been written into the storage cell.
The AVI functions of the uc480_tools.dll now supports
UNICODE strings for file names.
The sample programs contain two new samples for .NET
programming.
The is_IO() function has been extended so that small flash
duration and flash delay can be set for flash via the GPIOs.
New in Version 4.01
Cameras & functions
Support of the DCC1240x/DCC3240x with NIR sensor
New camera family GigE uEye LE as board-level camera.
Additional shutter modes and Log mode for DCC1240x/DCC3240x
cameras
The is_DeviceFeature() function was enhanced to control and
set the shutter modes and the Log mode of the DCC1240x/
DCC3240x.
New function is_Blacklevel() for controlling the black level
The is_IO() function was enhanced to control the configuration of
the GPIOs.
Information in this manual
With the is_Blacklevel() function the following uc480 function
is now obsolete:
is_SetBlCompensation()
New in Version 4.00
Cameras & functions
New camera family: DCC3240x
Added USB 3 specifications to the chapter about the USB interface
New function is_AutoParameter() enables/disables the auto
white balance. This function is similar to the
is_SetAutoParameter() function but does not replace the
function completely in version 4.20.
The is_HotPixel() function supports now Unicode file names for
saving and loading of hotpixel lists.
New function for the conversion of a raw Bayer image into a the
desired output format.
New function for activating/deactivating the software edge filter.
New function for saving the camera parameter set in a file or the
camera EEPROM and loading from a file or the camera EEPROM
respectively.
New function for controlling the camera pixel clock.
New function for reading camera information.
510
Described in chapter
isavi_GetAVIFileNameW()
isavi_OpenAVIW()
372
See separate uc480 Samples Manual
is_IO()
280
Described in chapter
DCC1240x/DCC3240x Camera and sensor
data
461
DCx camera family
14
uc480 Viewer > Properties > Shutter
is_DeviceFeature()
is_Blacklevel()
170
is_IO()
280
Decsribed in chapter
Obsolete functions
379
Described in chapter
DCx camera family
14
Model comparison
459
Mechanical Specifications DCC3240x
Camera Interface DCC3240x
USB interface
51
is_AutoParameter()
is_HotPixel()
260
is_Convert()
188
is_EdgeEnhancement()
is_ParameterSet()
is_PixelClock()
294
is_DeviceInfo()
196
© 2013 Thorlabs GmbH
365
115
192
474
491
167
206
292