Is_Setconvertparam - THORLABS DCU223x Operation Manual And Sdk

4.5.32 is_SetConvertParam

USB 2.0
Syntax
INT is_SetConvertParam (HIDS hCam,
Description
Attention
This function is obsolete and should not be used anymore. We recommend to use the
instead (see also Obsolete functions
Using is_SetConvertParam(), you can set the parameters for converting a raw Bayer image to a color image.
To convert the image, use the
Input parameters
hCam
ColorCorrection
BayerConversionMode
IS_SET_BAYER_CV_BETTER
IS_SET_BAYER_CV_BEST
ColorMode
Gamma
WhiteBalanceMultipliers
Return values
IS_INVALID_COLOR_FORMAT
IS_INVALID_CAMERA_HANDLE
IS_INVALID_PARAMETER
IS_NO_SUCCESS
IS_SUCCESS
Related functions
is_ConvertImage()
is_SetColorMode()
is_SetColorConverter()
© 2013 Thorlabs GmbH
USB 2.0
BOOL ColorCorrection,
INT BayerConversionMode, INT ColorMode, INT Gamma,
double* WhiteBalanceMultipliers)
).
379
is_ConvertImage()
Invalid color format
Invalid camera handle
One of the submitted parameters is outside the valid range or is not
supported for this sensor or is not available in this mode.
General error message
Function executed successfully
382
319
315
function.
382
Camera handle
Enables/disables color correction.
Sets the Bayer conversion mode.
Normal quality
Best quality (higher CPU load)
Sets the color mode for the output image.
For a list of all available color formats and the
associated input parameters, see the
and memory formats
Gamma value multiplied by 100. Range: [1...1000]
Pointer to an array containing the red, green and blue
gain values
4 Programming (SDK)
is_Convert()
Appendix: Color
section.
502
function
188
423