Uc480 Hotpixel Editor - THORLABS DCU223x Operation Manual And Sdk

3.4.4 uc480 Hotpixel Editor

During manufacturing, each DCx camera is tested and calibrated for hot pixels (aka bad pixels), which are caused
by technical reasons (see also
this factory calibration. Using the uc480 Hotpixel Editor, you can now edit the sensor hot pixel list stored in the
camera.
The uc480 Hotpixel Editor can be accessed as follows:
Start > All programs > uc480 > uc480 Hotpixel Editor
After program start, the uc480 Hotpixel Editor shows the following window:
In the toolbar on the top the following functions are provided:
Open camera
Opens the camera that is marked in the camera list.
Close camera
Closes the camera that is marked in the camera list.
Badpixel correction
Turns the hot pixel correction on/off.
Detect Badpixel
125
Opens the dialog for the automatic hot pixel detection.
Write Badpixel
Writes the list of the hot pixel to the EEPROM.
Add Badpixel
Writes the marked hot pixel in the hot pixel list of the program.
Delete Badpixel
Deletes a hot pixel from the hot pixel list of the program.
© 2013 Thorlabs GmbH
Camera basics: Sensor: Hot pixels ). In some cases, users may wish o extend
28
3 Operation
123