Ln1000-V Rear Transition Module Console Ports; Figure 6: Ln1000-V Rear Transition Module - Back View; Figure 7: Ln1000-V Rear Transition Module - Front Panel; Table 5: Pinouts For The Rj-45 (Npu), Shmm, And Ipmc Console Port - Juniper LN1000-V Hardware Manual

LN1000-V Mobile Secure Router Hardware Guide
Connector
LN1000–V Rear Transition Module Console Ports
Locking screw USB port
Ejector latch ShMM IPMC NPU
Table 5: Pinouts for the RJ-45 (NPU), shMM, and IPMC Console Port Connectors
Pin Setting
1 NC
2 RXD
3 TXD
4 NC
5 GND
24
Figure 6: LN1000-V Rear Transition Module — Back View
The shMM console port is the console port for the optional shMM module on the RTM.
The settings are baud rate of 19200 8N1, no flow control. You can use this port to send
and receive debug console commands to and from the shelf manager.
The IPMC console port is the console port for the IPMC controller on the LN1000-V board.
The settings are baud rate of 115200 8N1, no flow control. This is a debug output only
port.
The RS-232 console port, labeled NPU, accepts an RJ-45 connector and is located on
the front panel of the LN1000-V rear transition module. The settings are baud rate of
9600 8N1, no flow control. You can use this console port to monitor system startup and
for system repair. This console port is also available from the front panel of the LN1000-V
router. See "Router Console Port" on page 4 for more information.
Figure 7: LN1000-V Rear Transition Module — Front Panel
7
Description
No connect.
Transmit data into the LN1000–V router.
Transmit data out from the LN1000–V router.
No connect.
Ground.
IPMI Shelf Manager
LINK
6 5 4 3 2
Ethernet ports
ACT PWR OK Locking screw
1 0
Ejector latch
Copyright © 2010, Juniper Networks, Inc.