Configuration Steps; Customize Notification Prompts; Figure 1: Recording Custom Prompt - Grandstream Networks UCM6 Series Manual

CONFIGURATION STEPS

In the following sections, we will be covering all necessary steps to configure the system to fulfill the
requirements discussed on the scenario overview section. First, we need to setup the prompts that we will
be played to the users when someone dials an emergency number.
Note: If no custom prompt is configured, the PBX will play the default one.

Customize Notification Prompts

In order to create a custom prompt that will be used as notification when an emergency
call is initiated, users need to log to the web administration page of the UCM under "PBX
Settings → Voice Prompt → Custom Prompt" then they have two choices:
1. Upload a pre-recorded prompt by pressing the button
the following specs:
•
PCM encoded.
•
16 bits.
•
8000Hz mono.
•
In .mp3 or .wav format; or raw/ulaw/alaw/gsm file with .ulaw or .alaw suffix.
•
File size under 5M.
Note: If uploading a compressed file, the file must have .tar/.tgz/.tar.gz suffix, name must contain only
letters, numbers or special characters -_. and the file size must be less than 30MB.
2. Record a new custom prompt by clicking on
which you want to record.

Figure 1: Recording Custom Prompt

UCM6xxx Emergency Calls Guide
but the file should respect
then select the recording station on
P a g e | 6