Using Emulation Mode - Extron electronics HDXP Plus Series User Manual

•
Frequency-read options
signal detection (DSVP) feature to do one of the following:
Automatically refresh the display (set this option to
•
10 seconds
Sample the sync and update the display whenever you make a configuration
•
change (set this option to
Never sample and display the sync or no sync status (set this option to
•
•
Limit ties to same group
outputs that are in the same group (similar to front panel operation).
•
Icons in I/O boxes
the Matrix window (see
•
Numbers in I/O boxes
boxes in the Matrix window (see the
are not able to place icons in the boxes when this option is selected.
•
Catch FPC/other's Changes
configuration and setting changes to the Remote RS-232/RS-422 or Ethernet
connection that enabled this selection. These reports allow the Matrix Switcher
Control Program to track the changes that occur in the switcher configuration and
settings, whether commanded via the front panel, the RS232/RS422 port, or the
Ethernet port.
Master-Reset selection
Master-Reset
NOTE:

Using Emulation Mode

Emulation mode allows you to set up the software without attaching the switcher to the
computer. In emulation mode, you can emulate any matrix switcher that is supported by
the Matrix Switcher Control Program; you are not limited to the HDXP.
To use emulation mode, do the following:
1. Double-click the
Electronics group or folder.
2. On the Comm Port Selection window, select
— Provides a submenu that allows you to set the input
).
On Demand or by Refresh
— Allows you to create ties only between inputs and
— Displays icons that you place in the I/O boxes in
figure 86
— Displays the input and output numbers in the I/O
— When checked, sets the switcher to report all
clears all ties and presets, all output mutes, and all I/O grouping.
does not reset the Internet protocol (IP) settings.
Master-Reset
MATRIX Switchers + Control Program
HDXP Plus Series Switchers • Matrix Software
Automatically every
).
on the previous page).
figure 87 on the previous page). You
icon in the Extron
, and click
Emulate
).
None
.
OK
89