Using The Software - Extron electronics HDXP Plus Series User Manual

Using the Software

Many items in the Windows-based Matrix Switcher Control Program are also accessible
via front panel controls (see the
control (see the
and via the web pages (see the
page 96). The Matrix Switcher Control Program help file provides information on settings
and on how to use the control program itself.
1. To run the Matrix Switcher Control Program, click the
Switcher + Control Pgm
Electronics group or folder on your
You can access this icon from your
following:
Start
Matrix Switcher + Control Program
The Comm Port Selection window opens (see figure 70).
FIG_Comm Port Selection
Figure 70.
2. Choose the comm port that is connected to the HDXP RS232/RS422 port, or select
IP [LAN]
If you selected a Comm port:
•
a.
b.
Operation
Remote Configuration and Control
HTML Configuration and Control
icon (shown at right) in the Extron
> >
All Programs Extron Electronics
F
Comm Port Selection Window
or .
Emulate
Check the baud rate displayed in the Comm Port Selection window. If you
need to change the baud rate, click the
pop-up list (after you click it, the
Double-click on the desired baud rate (available selections are
, and ; the default is
38400 115200
HDXP Plus Series Switchers • Matrix Software
section beginning on page 13), under SIS
section beginning on page 45),
Matrix
menu.
Start
menu by selecting the
Start
>
Matrix Switchers
button to display the baud rate
Baud
button changes to
Baud
).
9600
section beginning on
>
).
OK
, ,
9600 19200
70