Extron electronics HDXP Plus Series User Manual page 70

Command
IP Setup Commands (continued)
Bidirectional Serial Port (continued)
Configure flow control
24
View flow control
Configure receive timeout
24
View receive timeout
Send data string (web
encoding only)
X1& X1* X5^
NOTE: The *
X1&
NOTE: = Receive timeout
X1*
= Interval between characters
X4^
= Serial port number
X5@
= Flow control
X5#
= Data pacing
X5%
= Command data (for web encoding) Data is directed to the specified port and must be encoded as follows
X5^
= Command length or delimiter
X6*
= Message length or delimiter
X6(
= Priority status for receive timeouts
ASCII Command
(Host to Switcher)
E X4^ X5@ X5# }
* , CF
E X4^ }
CF
E X4^ X1& X1* X6(
* * *
E X4^ }
CE
E X4^ X1& X1* X5^
* * *
X1&
sequence is optional. If and
Time in tens of ms to wait for characters to arrive at the serial port
before terminating the connection. Default = 10 (100 ms).
Maximum = 32,767.
Time in tens of ms to wait between characters coming into the serial
port before terminating the connection. Default = 2 (20 ms).
Maximum = 32,767.
01 = RS232/RS422 port on rear panel, 02 = front panel Config port
H = hardware, S = software, N = none
Number of milliseconds between bytes (0000 – 1000). Default is 0.
if it is not alphanumeric:
• Space (hex 20) should be encoded as %20 (hex 25 32 30)
• Plus sign (hex 2B) should be encoded as %2B (hex 25 32 42)
Parameter to set either the length of the message to be received or a
delimiter value. Parameter is case-sensitive—it must be uppercase.
# is the
#L = length of the command to be received: 0
#D = delimiter value: 0 through 00255. The default is the byte
Parameter to set either the length of the message to be received or a
delimiter value. Parameter is case-sensitive—it must be uppercase.
L = length in bytes. Min = 0, max = 32767. Default is 0L (0 bytes).
D = decimal value for ASCII character (delimiter). Min = 0,
max = 00255. Default is 00000L.
Value precedes parameter; for example, 3-byte length = 3L.
0 = Use Send data string command parameters.
1 = Use configure receive timeout command parameters.
Default is 0.
HDXP Plus Series Switchers • Remote Configuration and Control
Response
(Switcher to Host)
X4^ X5@ X5# ]
Cpn • Cfl ,
X5@ X5# ]
,
X6* }
* CE
X4^ X1& X1* ]
Cpn • Cce ,
X1& X1* X6( X6* ]
, , ,
} X5%
RS
Response to command
X1*
are not specified, the default values are used.
L
byte count for or a single ASCII character in decimal format for
The default is 0. Example: A 3-byte length = 3L.
count.
Additional Description
X5@
Set flow control and data
X5# X4^
pacing rate for port .
X5#
View data rate for flow
X5@ X4^
control for port .
Set receive timeout
X4^
parameters for port :
X1&
Timeout after ms for
•
arriving characters
X1*
Timeout after ms
•
between characters
Message length or delimiter
•
X6*
value .
X6(
Receive priority status .
•
View the receive timeout
parameters.
X5%
Send command data to
X4^
port .
D
.
32767.
through
64