Viewing Nat Status - Motorola RFS Series Reference Manual

6-40 Motorola RF Switch System Reference Guide
a. Click the
b. Use the
the switch managed network and its destination (within the insecure outside world).
c. Use the
• Inside - The set of switch-managed networks subject to translation. These are the internal addresses
you are trying to prevent from being exposed to the outside world.
• Outside - All other addresses. Usually these are valid addresses located on the Internet. Outside
addresses pose no risk if exposed over a publicly accessible network.
d. Refer to the
messages if something goes wrong in the transaction between the applet and the switch.
e. Click OK
f. Click Cancel

6.6.4 Viewing NAT Status

Use the Status
the inside and outside local and global IP addresses.
To view and configure a NAT interface:
1. Select Security
Add button from within the Interfaces tab.
Interface drop-down menu to select the VLAN used as the communication medium between
Type drop-down menu to specific the Inside or Outside designation as follows:
Status field for the state of the requests made from applet. This field displays error
to use the changes to the running configuration and close the dialog.
to close the dialog without committing updates to the running configuration.
tab to review the NAT translations configured thus far for the switch. The Status tab displays
> NAT from the main menu tree.