Configuring Ipsec Vpn Authentication - Motorola RFS Series Reference Manual

6-56 Motorola RF Switch System Reference Guide
Starting IP Address
Ending IP Address
5. Click the Edit
6. Select an IP address range index and click the
within the IP Range tab.
7. To add a new range of IP addresses, click the
in the fields provided. Click
8. Click Cancel

6.8.3 Configuring IPSEC VPN Authentication

If IKE is not used for establishing security associations, there is no negotiation of security associations.
Consequently, the configuration information in both systems must be the same for traffic to be processed
successfully by the IPSec resource. Select the
mechanisms used with the IPSEC VPN configuration.
To define the IPSEc VPN authentication configuration:
1. Select Security
Enter the numerical IP address used as the starting address for the range defined.
If the Ending IP address is left blank, only the starting address is used for the
remote destination.
Enter a numerical IP address to complete the range. If the Ending IP address is
blank, only the starting address is used as the destination address.
button (within the IP Range tab) to modify the range of existing IP addresses displayed.
OK when completed to save the changes.
to disregard the changes and revert to the last saved configuration.
> IPSec VPN from the main menu tree.
Delete button to remove this range from those available
Add button (within the IP Range tab) and define the range
Authentication tab to define the credential verification