Motorola RFS Series Reference Manual page 171
Wireless lan switches wing system
Hide thumbs
Also See for RFS Series:
- Reference manual (948 pages) ,
- System reference manual (590 pages) ,
- Reference manual (1054 pages)
Table of Contents
Advertisement
• Information
• Traffic
• RF Status
• Errors
Information in black represents the statistics from the last 30 seconds and information in blue represents
statistics from the last hour. Use both sets of data to trend stats in real time versus a measurable period
(1 hour).
4. Refer to the
Information
MAC Address
Displays the Hardware or Media Access Control (MAC) address for the MU. This
address is hard-coded at the factory and cannot be modified.
BSS Address
Displays the MU's BSSID.
IP Address
Displays the current IP address for the MU.
Voice
Displays whether the MU is a voice capable device. Traffic from voice enabled
MUs is handled differently (higher priority) than traffic from MUs without this
capability.
WLAN
Displays the name of the WLAN the MU is currently associated with.
WMM
Displays WMM usage status for the MU, including the access category currently
in use. Use this information to assess whether the MU is using the correct WMM
settings in relation to its intended data traffic type.
5. Refer to the
Traffic
field for the following information:
Pkts per second
Displays the average packets per second received by the MU. The Rx column
displays the average packets per second received on the selected MU. The Tx
column displays the average packets per second sent on the selected MU.
Throughput
Displays the average throughput in Mbps between the MU and the Access Port.
The Rx column displays the average throughput in Mbps for packets received on
the selected MU from the Access Port. The Tx column displays the average
throughput for packets sent on the selected MU from the Access Port.
Avg. Bit Speed
Displays the average bit speed in Mbps on the selected MU. This includes all
packets sent and received.
% Non-unicast pkts
Displays the percentage of the total packets for the MU that are non-unicast
packets. Non-unicast packets include broadcast and multicast packets.
6. Refer to the
RF Status
Avg MU Signal
Displays the RF signal strength in dBm for the selected MU.
Avg MU Noise
Displays the RF noise for the selected MU.
Avg MU SNR
Displays the Signal to Noise Ratio (SNR) for the selected MU. The Signal to Noise
Ratio is an indication of overall RF performance on the wireless network.
field for the following information:
field for the following information:
4-83
Network Setup
Advertisement
Table of Contents
