Motorola RFS Series Reference Manual page 131

a. Specify a source hotspot configuration file. The file used at startup automatically displays within the
File parameter.
b. Refer to the Using
FTP or TFTP.
c. Enter the IP Address
IP address is valid or risk jeopardizing the success of the file transfer.
d. If using FTP, enter the
server.
e. If using FTP, enter the
f. Specify the appropriate
g. Once the location and settings for the advanced hotspot configuration have been defined, click the
Install button to use the hotspot configuration with the switch.
6. Refer to the
Allow List
accessed by the Hotspot user without authentication.
7. Check the Use System Name in Hotspot URL
configuration screen as part of the hotspot address.
8. Specify the maximum Hotspot Simultaneous Users
hotspot users for the selected WLAN.
9. Check the Logout on Browser Close
their web browsers.
10.Refer to the Status field for the current state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
11.Click OK to use the changes to the running configuration and close the dialog.
12.Click Cancel to close the dialog without committing updates to the running configuration.
Configuring MAC Authentication
The MAC Authentication option allows the user to configure a Radius server for user authentication with the
range of MAC addressees defined as allowed or denied access to the switch managed network.
NOTE: As part of the MAC Authentication process, ensure a primary and optional
secondary Radius Server have been properly configured to authenticate the users
requesting access to the ACL supported WLAN. For more information on configuring
Radius Server support for the MAC Authentication supported WLAN, see
External Radius Server Support on page
To configure the format of MAC addresses used in MAC Authentications:
1. Select Network > Wireless LANs
2. Select an existing WLAN from those displayed within the
3. Click the Edit button.
4. Select the MAC Authentication
This enables the Radius
drop-down menu to configure whether the hotspot file transfer is conducted using
of the server or system receiving the source hotspot configuration. Ensure the
User ID credentials required to transfer the configuration file from a FTP
Password required to send the configuration file from an FTP server.
Path name to the hotspot configuration on the local system disk or server.
field, and enter any IP address (for internal or external Web sites) that may be
to use the
button to logout hotspot users from the network when they close
from the main menu tree.
button from within the Authentication field.
button at the bottom of the
System Name specified on the main Switch
to set a limit on the number of concurrent unique
4-44.
Configuration tab.
Network > Wireless LANs
4-43
Network Setup
Configuring
> Edit screen.