Viewing Filtered Mus - Motorola RFS Series Reference Manual

6-12 Motorola RF Switch System Reference Guide
Radio
Switch
Time to Filter
CAUTION: Setting MU threshold values too low can jeopardize MU performance or break
the MU's connection.
5. When using the
known bad ESSIDs for the violation parameter. To enter this information, select
bad ESSIDs
can be added and removed.
NOTE: If using the
are entered in the
6. Click on Apply
7. Click on Revert

6.3.2 Viewing Filtered MUs

Periodically check the
on the settings defined within the
attributes exported to a user defined location.
To view status of those MUs filtered using the settings defined within the
1. Select Security
Set the radio threshold value for each violation type. If exceeded, the MU is
filtered and displayed within the Filtered MUs screen.
Set the switch's threshold value for each violation type. If exceeded, the offending
MU is filtered (from the switch) and displayed within the Filtered MUs screen.
Set the Time to Filter interval (in seconds) the switch uses to filter out MUs defined
as committing a violation. Refer to
the contents of the MUs that have been filtered thus far.
Frames with known bad
and then click the Bad Essid Config
Frames with known bad ESSIDs
Bad Essid Config
button to save the configuration.
to rollback to the previous configuration.
Filtered MUs tab to review MUs filtered by the switch for incurring a violation based
Configuration
> Mobile Unit Intrusion Detection
Viewing Filtered MUs on page 6-12
ESSIDs violation parameter it is necessary to enter a list of
button to launch a dialogue box where bad ESSIDs
violation parameter if no ESSIDs
dialogue, this parameter will not function.
tab. Each MU listed can be deleted from the list or its
from the main tree menu.
to review
Frames with known
Configuration tab: