B.3 Freset Clear Selected Data From Nvm And Reset; Freset Target - Novatel AG-Star User Manual

B.3 FRESET Clear Selected Data from NVM and Reset

The OEMStar freset command is extended to include AG-Star features. An additional target field, userdata
(value = 10), resets only the AG-Star user data NVM, thereby resetting all parameters indicated in this
document as "Stored in NVM" to factory defaults. Issuing the freset command with the "target" field set to
standard, resets the userdata NVM as well as OEMStar parameters as indicated in the
Reference Manual.

If you issue the FRESET command without any parameters, it is the same as issuing a
FRESET STANDARD command.
Field ASCII
Field
Type Value
1 FRESET -
header
2 target See Table 11,
FRESET Target on
page 53
Binary
0 STANDARD
1 COMMAND
2 GPSALMANAC
3 GPSEPHEM
4 GLOEPHEM
5 MODEL
10 USERDATA
11 CLKCALIBRATION
20 SBASALMANAC
21 LAST_POSITION
31 GLOALMANAC
AG-Star User Manual Rev 4
Binary
Value
- This field contains the command name
or the message header depending on
whether the command is abbreviated
ASCII, ASCII or binary.
Data to be reset by the receiver
Table 11: FRESET Target
ASCII
Resets commands, ephemeris, and almanac (default).
Resets the stored commands (saved configuration)
Resets the stored GPS almanac
Resets the stored GPS ephemeris
Resets the stored GLONASS ephemeris
Resets the currently selected model
Reset AG-Star only commands
Resets the parameters entered using the CLOCKCALIBRATE command
Resets the stored SBAS almanac
Resets the position using the last stored position
Resets the stored GLONASS almanac
Description
Description
OEMStar Firmware
Binary Binary Binary
Format Bytes Offset
- H 0
Enum 4 H
53