Traffic Mirroring; Qos Configuration; Configuring Priority Trust Mode - H3C S5600 SERIES Operation Manual

Hide thumbs Also See for S5600 SERIES:

Table of Contents

Although the burst function helps reduce the packet loss ratio and improve packet

processing capability in the networks mentioned above, it may affect QoS performance. So,

use this function with caution.

Traffic mirroring

Traffic mirroring identifies traffic using ACLs and duplicates the matched packets to the

destination mirroring port or CPU depending on your configuration. For information about

port mirroring, refer to the Mirroring module of this manual.

Complete the following tasks to configure QoS:

Configuring the Mapping between 802.1p Priority and Local

Setting the Priority of Protocol Packets

Marking Packet Priority

Configuring Traffic Policing

Configuring Line Rate

Configuring Traffic Redirecting

Configuring VLAN Mapping

Configuring Queue Scheduling

Configuring Traffic Accounting

Enabling the Burst Function

Configuring Traffic Mirroring

Configuring Priority Trust Mode

Refer to section

Configuration prerequisites

The priority trust mode to be adopted has been determined.

The port where priority trust mode is to be configured has been determined.

The port priority value has been determined.

Configuration procedure

Follow these steps to configure to trust port priority:

Priority Trust Mode

for introduction to priority trust mode.

Table of Contents