AudioCodes Mediant 2000 User Manual page 323

SIP User's Manual
Parameter
EnableETSIDiversion
CopyDest2RedirectNumber
FilterCalls2IP
Alternative Routing Parameters
RedundantRoutingMode
AltRoutingTel2IPEnable
AltRoutingTel2IPMode
AltRoutingTel2IPConnMethod
AltRoutingTel2IPKeepAliveTim
e
IPConnQoSMaxAllowedPL
IPConnQoSMaxAllowedDelay
Version 5.6
AltRouteCauseIP2Tel_ReleaseCause;
[\AltRouteCauseIP2Tel]
For example:
[AltRouteCauseIP2Tel]
AltRouteCauseIP2Tel 0 = 3
AltRouteCauseIP2Tel 1 = 1
AltRouteCauseIP2Tel 2 = 17 (Busy Here)
[\AltRouteCauseIP2Tel]
Notes:
This parameter can include up to 5 indices.
If the device fails to establish a call to the PSTN because it
has no available channels in a specific trunk group (e.g., all
trunk group's channels are occupied, or the trunk group's
spans are disconnected or out of sync), it uses the Internal
Release Cause '3' (No Route to Destination). This cause can
be used in the AltRouteCauseIP2Tel table to define routing to
an alternative trunk group.
For defining the Reasons for Alternative Routing table using
the Web interface, refer to ''Reasons for Alternative Routing''
on page 188.
For an explanation on usng ini file table parameters, refer to
''Structure of ini File Table Parameters'' on page 257.
Defines the method in which the Redirect Number is passed
toward the Tel side.
[0] = Q.931 Redirecting Number Information Element (IE)
(default)
[1] = ETSI DivertingLegInformation2 in a Facility IE
For a description of this parameter, refer to "Configuring the
Digital Gateway Parameters" on page 207.
For a description of this parameter, refer to ''Advanced
Parameters'' on page 151.
For a description of this parameter, refer to ''Proxy & Registration
Parameters'' on page 132.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 171.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 171.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 171.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 171.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 171.
For a description of this parameter, refer to ''Routing General
Parameters'' on page 171.
323
4. ini File Configuration
Description
(No Route to Destination)
(Unallocated Number)
November 2008