AudioCodes Mediant 2000 User Manual page 212

Parameter
Enable Calling Party Category
[EnableCallingPartyCategory]
Digital Out-Of-Service Behavior
[DigitalOOSBehavior]
SIP User's Manual
performs Tel-to-IP destination phone number manipulation.
Therefore, this allows you to have different numbers for the
called (i.e., SIP To header) and redirected (i.e., SIP Diversion
header) numbers.
Notes:
If the incoming ISDN-to-IP call includes a Redirect Number,
this number is overridden by the new called number if this
parameter is set to 1 or 2.
This parameter can also be configured for IP Profiles (refer to
''IP Profile Settings'' on page 193).
Determines whether Calling Party Category (CPC) is mapped
between SIP and PRI.
[0] Disable = Don't relay the CPC between SIP and PRI
(default).
[1] Enable = The CPC is relayed between SIP and PRI.
If enabled, the CPC received in the Originating Line Information
(OLI) IE of an incoming ISDN SETUP message is relayed to the
From / P-Asserted-Identity headers using the 'cpc' parameter, in
the outgoing INVITE message, and vice versa.
For example (calling party is a payphone):
From:<sip:2000;cpc=payphone@10.8.23.70>;tag=1c1806157451
Note: This feature is supported only when using the NI-2 PRI
variant.
Determines the method for setting digital trunks to Out-Of-
Service state per device.
[0] Default = Uses default behavior for each trunk - see note
below (default)
[1] Service = Sends ISDN In or Out of Service (only for ISDN
protocols that support Service message).
[2] D-Channel = Takes D-Channel down or up (ISDN only).
[3] Alarm = Sends or clears PSTN AIS Alarm (ISDN and
CAS).
[4] Block = Blocks trunk (CAS only).
Notes:
The default behavior (value 0) is as follows:
- ISDN: Use Service messages on supporting variants and
use Alarm on non-supporting variants.
- CAS: Use Alarm.
When updating this parameter value at run-time, you must
stop the trunk and then restart it for the update to take effect.
To determine the method for setting Out-Of-Service state per
trunk, use the DigitalOOSBehaviorFor Trunk_ID parameter
(refer to ''Trunk Settings'' on page 82).
212
Description
Document #: LTRT-68808
Mediant 2000