AudioCodes Mediant 2000 User Manual page 269
Media sip gateway
Hide thumbs
Also See for Mediant 2000:
- User manual (702 pages) ,
- Installation manual (44 pages) ,
- Hardware installation manual (30 pages)
Table of Contents
Advertisement
SIP User's Manual
Parameter
ECHybridLoss
GwDebugLevel
CDRReportLevel
CDRSyslogServerIP
HeartBeatDestIP
HeartBeatDestPort
HeartBeatIntervalmsec
EnableRAI
RAIHighThreshold
RAILowThreshold
Version 5.6
(4) ActivityListToLog
For example: ActivityListToLog = 'pvc', 'afl', 'dr', 'fb', 'swu', 'ard', 'naa',
'spc'
Sets the four wire to two wire worst-case Hybrid loss, the ratio
between the signal level sent to the hybrid and the echo level
returning from the hybrid.
[0] = 6 dB (default)
[1] = N/A
[2] = 0 dB
[3] = 3 dB
For a description of this parameter, refer to ''Advanced Parameters''
on page 151.
For a description of this parameter, refer to ''Advanced Parameters''
on page 151.
For a description of this parameter, refer to ''Advanced Parameters''
on page 151.
Destination IP address (in dotted format notation) to which the device
sends proprietary UDP 'ping' packets.
The default IP address is 0.0.0.0.
Destination UDP port to which the heartbeat packets are sent.
The range is 0 to 64000. The default is 0.
Delay (in msec) between consecutive heartbeat packets.
[10] = 100000.
[-1] = disabled (default).
[0] = Disable RAI (Resource Available Indication) service (default).
[1] = Enable RAI service.
If RAI is enabled, an SNMP 'acBoardCallResourcesAlarm' Alarm Trap
is sent if device's busy endpoints exceed a predefined (configurable)
threshold.
High threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this High Threshold, the device sends the SNMP
acBoardCallResourcesAlarm Alarm Trap with a 'major' Alarm Status.
The range is 0 to 100. The default value is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of "enabled"
endpoints(trunks are physically connected and synchronized with no
alarms and endpoints are defined in the Trunk Group table).
Low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this
Low Threshold, the device sends an SNMP
acBoardCallResourcesAlarm Alarm Trap with a 'cleared' Alarm Status.
The range is 0 to 100%. The default value is 90%.
269
4. ini File Configuration
Description
November 2008
Advertisement
Table of Contents
