Figure 3-101: Software Upgrade Key With Multiple S/N Lines - AudioCodes Mediant 2000 User Manual
Media sip gateway
Hide thumbs
Also See for Mediant 2000:
- User manual (702 pages) ,
- Installation manual (44 pages) ,
- Hardware installation manual (30 pages)
Table of Contents
Advertisement
SIP User's Manual
•
Multiple S/N lines (as shown below):
Figure 3-101: Software Upgrade Key with Multiple S/N Lines
a.
b.
Verify that the Software Upgrade Key file was successfully loaded to the device, by
5.
using one of the following methods:
•
In the 'Key features' group, ensure that the features and capabilities activated by
the installed string match those that were ordered.
•
Access the Syslog server (refer to the Product Reference Manual) and ensure
that the following message appears in the Syslog server:
"S/N___ Key Was Updated. The Board Needs to be Reloaded with ini file\n".
Reset the device; the new capabilities and resources are active.
6.
Note:
3.5.2.2.1 Loading via BootP/TFTP
The procedure below describes how to load a Software Upgrade Key to the device using
AudioCodes' BootP/TFTP Server utility (for a detailed description on the BootP utility, refer
to the Product Reference Manual).
To load a Software Upgrade Key file using BootP/TFTP, take these
6 steps:
Place the Software Upgrade Key file (typically, a *.txt file) in the same folder in which
1.
the device's cmp file is located.
Start the BootP/TFTP Server utility.
2.
Version 5.6
in the 'Send Upgrade Key file' field, click the Browse button and navigate to
the folder in which the Software Upgrade Key text file is located on your PC.
Click the Send File button; the new key is loaded to the device and
validated. If the key is valid, it is burned to memory and displayed in the
'Current Key' field.
If the Syslog server indicates that the Software Upgrade Key file was
unsuccessfully loaded (i.e., the 'SN_' line is blank), perform the following
preliminary troubleshooting procedures:
Open the Software Upgrade Key file and check that the S/N line
1.
appears. If it does not appear, contact AudioCodes.
Verify that you've loaded the correct file. Open the file and ensure that
2.
the first line displays [LicenseKeys].
Verify that the contents of the file has not been altered in any way.
3.
235
3. Web-Based Management
November 2008
Advertisement
Table of Contents
