AudioCodes Mediant 2000 User Manual page 272

Parameter
BootP and TFTP Parameters
The BootP parameters are special 'Hidden' parameters. Once defined and saved in the flash memory,
they are used even if they don't appear in the ini file.
BootPRetries
BootPSelectiveEnable
BootPDelay
SIP User's Manual
Note: This parameter only takes effect from the next reset of the
device.
This parameter is used to:
Set the number of BootP requests the
device sends during start-up. The
device stops sending BootP requests
when either BootP reply is received or
number of retries is reached.
[1] = 1 BootP retry, 1 sec.
[2] = 2 BootP retries, 3 sec.
[3] = 3 BootP retries, 6 sec.
(default).
[4] = 10 BootP retries, 30 sec.
[5] = 20 BootP retries, 60 sec.
[6] = 40 BootP retries, 120 sec.
[7] = 100 BootP retries, 300 sec.
[15] = BootP retries indefinitely.
Enables the Selective BootP mechanism.
[1] = Enabled.
[0] = Disabled (default).
The Selective BootP mechanism (available from Boot version 1.92)
enables the device's integral BootP client to filter unsolicited
BootP/DHCP replies (accepts only BootP replies that contain the text
'AUDC' in the vendor specific information field). This option is useful in
environments where enterprise BootP/DHCP servers provide
undesired responses to the device's BootP requests.
Note: When working with DHCP (DHCPEnable = 1) the selective
BootP feature must be disabled.
The interval between the device's startup and the first BootP/DHCP
request that is issued by the device.
[1] = 1 second (default).
[2] = 3 second.
[3] = 6 second.
[4] = 30 second.
[5] = 60 second.
Note: This parameter only takes effect from the next reset of the
device.
272
Description
Set the number of DHCP
packets the device sends.
After all packets were sent,
if there's still no reply, the
device loads from flash.
[1] = 4 DHCP packets
[2] = 5 DHCP packets
[3] = 6 DHCP packets
(default)
[4] = 7 DHCP packets
[5] = 8 DHCP packets
[6] = 9 DHCP packets
[7] = 10 DHCP packets
[15] = 18 DHCP packets
Document #: LTRT-68808
Mediant 2000