AudioCodes Mediant 2000 User Manual page 86

ini File Field Name
Web Parameter Name
Trunk Configuration
Clock Master
[ClockMaster]
Auto Clock Trunk Priority
[AutoClockTrunkPriority]
Line Code
[LineCode]
Line Build Out Loss
SIP User's Manual
Valid Range and Description
[13] T1 5ESS 10 ISDN
[14] T1 DMS100 ISDN
[15] J1 TRANSPARENT
[16] T1 NTT ISDN = Japan - Nippon Telegraph
[17] E1 AUSTEL ISDN = Australian Telecom
[18] T1 HKT ISDN = Hong Kong - HKT
[19] E1 KOR ISDN = Korean operator
[20] T1 HKT ISDN = Hong Kong - HKT over T1
[21] E1 QSIG
[23] T1 QSIG
[30] E1 FRENCH VN6 ISDN
[31] E1 FRENCH VN3 ISDN
[35] T1 DMS100 Meridian ISDN
[40] E1 NI2 ISDN
[41] E1 CAS R15
Note: The device simultaneously supports different variants of CAS
and PRI protocols on different E1/T1 spans (no more than four
simultaneous PRI variants). The device simultaneously supports
different BRI variants
Determines the Tx clock source of the E1/T1 line.
[0] Recovered = Generate the clock according to the Rx of the
E1/T1 line (default).
[1] Generated = Generate the clock according to the internal
TDM bus.
Notes:
The source of the internal TDM bus clock is determined by the
parameter TDMBusClockSource.
For detailed information on configuring the device's clock
settings, refer to ''Clock Settings'' on page 393.
Defines the trunk priority for auto-clock fallback (per trunk
parameter).
0 to 99 = priority (0 is the highest = default).
100 = the SW never performs a fallback to that trunk (usually
used to mark untrusted source of clock).
Note: Fallback is enabled when the TDMBusPSTNAutoClockEnable
parameter is set to 1.
Use to select B8ZS or AMI for T1 spans, and HDB3 or AMI for E1
spans.
[0] B8ZS = use B8ZS line code (for T1 trunks only) default.
[1] AMI = use AMI line code.
[2] HDB3 = use HDB3 line code (for E1 trunks only).
Defines the line build out loss for the selected T1 trunk.
86
Mediant 2000
Document #: LTRT-68808