AudioCodes Mediant 2000 User Manual page 93

SIP User's Manual
ini File Field Name
Web Parameter Name
CAS Configuration (These parameters only appear if the protocol Type is
CAS Table
[CASTableIndex_x]
Dial Plan
[CasTrunkDialPlanName]
Miscellaneous
PSTN Alert Timeout
[TrunkPSTNAlertTimeout_I
D]
Digital Out-Of-Service
Behavior
[DigitalOOSBehaviorFor
Trunk_ID]
Version 5.6
Valid Range and Description
not identified as channel-id #16, but is still carried into the
timeslot #16.
When this bit is set, the channel ID #16 is considered as a valid
B-channel ID, but timeslot values are converted to reflect the
range 1 to 15 and 17 to 31. This is the new QSIG mode of
operation. When this bit is not set (default), the channel_id #16 is
not allowed, as for all ETSI-like standards.
[64] USE T1 PRI = PRI interface type is forced to T1.
[128] USE E1 PRI = PRI interface type is forced to E1.
[256] START WITH B CHAN OOS = B-channels start in the Out-
Of-Service state (OOS).
[512] CHAN ALLOC LOWEST = CC allocates B-channels
starting from the lowest available B-channel id.
[1024] CHAN ALLOC HIGHEST = CC allocates B-channels
starting from the highest available B-channel id.
Note: When using the ini file to configure the device to support
several ISDNGeneralCCBehavior features, add the individual feature
values. For example, to support both [16] and [32] features, set
ISDNGeneralCCBehavior = 48 (i.e., 16 + 32).
Defines CAS protocol for each trunk ID from a list of CAS protocols
defined by the parameter CASFileName_Y.
For example:
CASFileName_0 = 'E_M_WinkTable.dat'
CASFileName_1 = 'E_M_ImmediateTable.dat'
CASTableIndex_0 = 0
CASTableIndex_1 = 0
CASTableIndex_2 = 1
CASTableIndex_3 = 1
Trunks 0 and 1 use the E&M Winkstart CAS protocol, while trunks 2
and 3 use the E&M Immediate Start CAS protocol.
Note: For additional CAS table ini file parameters (CASFileName_0,
CASFileName_1, CASFileName_7, and CASTablesNum), refer to
''E1/T1 Configuration Parameters'' on page 303.
The Dial Plan name that is used on a specific trunk.
The range is up to 11 character strings.
Alert Timeout (ISDN T301 timer) in seconds for outgoing calls to
PSTN. This timer is used between the time that a SETUP message
is sent to the Tel side (IP-to-Tel call establishment) and a CONNECT
message is received. If ALERT is received, the timer is restarted.
In the ini file parameter, ID depicts the trunk number, where 0 is the
first trunk.
The range is 1 to 600. The default is 180.
Determines the method for setting digital trunks to Out-Of-Service
state per trunk.
[-1] Not Configured = Use the settings of the DigitalOOSBehavio
parameter for per device (default).
93
3. Web-Based Management
November 2008