Figure 7-6: Assign The Trunk To Trunk Group Id #1 In The Trunk Group Table; Figure 7-7: Configuring Trunk Group #1 For Registration Per Account In Trunk Group Settings; Figure 7-8: Configuring Accounts For Pbx Registration To Itsps In Account Table; Figure 7-9: Configuring Itsp-To-Trunk Group #1 Routing In Ip To Trunk Group Table - AudioCodes Mediant 2000 User Manual
Media sip gateway
Hide thumbs
Also See for Mediant 2000:
- User manual (702 pages) ,
- Installation manual (44 pages) ,
- Hardware installation manual (30 pages)
Table of Contents
Advertisement
In the 'Trunk Group Table' page (refer to "Configuring the Trunk Group Table" on page
4.
195), enable the Trunks connected between the Enterprise's PBX and the device
(Trunk Group ID #1), and between the local PSTN and the device (Trunk Group ID
#2).
Figure 7-6: Assign the Trunk to Trunk Group ID #1 in the Trunk Group Table Page
In the 'Trunk Group Settings' page (refer to ''Configuring the Trunk Group Settings'' on
5.
page 197), configure 'Per Account' registration for Trunk Group ID #1 (without serving
IP Group).
Figure 7-7: Configuring Trunk Group #1 for Registration per Account in Trunk Group Settings
In the 'Account Table' page (refer to ''Configuring the Account Table'' on page 204),
6.
configure the two Accounts for PBX trunk registration to ITSPs using the same Trunk
Group (i.e., ID #1), but different serving IP Groups #1 and #2. For each account, define
user name, password, and hostname, and ContactUser. The Register messages use
different URI's (Hostname and ContactUser) in the From, To, and Contact headers per
ITSP. Enable registration for both accounts. .
Figure 7-8: Configuring Accounts for PBX Registration to ITSPs in Account Table Page
In the 'IP to Trunk Group Routing' page (refer to ''IP to Trunk Group Routing'' on page
7.
181), configure IP-to-Tel routing for calls from ITSPs to Trunk Group ID #1 (see 1
below) and from the device to the local PSTN (see 2 below).
Figure 7-9: Configuring ITSP-to-Trunk Group #1 Routing in IP to Trunk Group Table Page
In the 'Tel to IP Routing' page (refer to ''Tel to IP Routing Table'' on page 175),
8.
configure Tel-to-IP routing rules for calls to ITSPs (see 1 below) and to local PSTN
(see 2 below) .
Figure 7-10: Configuring Tel-to-IP Routing to ITSPs in Tel to IP Routing Table Page
SIP User's Manual
Page
376
Mediant 2000
Document #: LTRT-68808
Advertisement
Table of Contents
