Figure 3-85: Account Table; Table 3-52: Account Parameters Description - AudioCodes Mediant 2000 User Manual
Media sip gateway
Hide thumbs
Also See for Mediant 2000:
- User manual (702 pages) ,
- Installation manual (44 pages) ,
- Hardware installation manual (30 pages)
Table of Contents
Advertisement
SIP User's Manual
Note:
To configure Accounts, take these 5 steps:
Open the 'Account Table' page (Configuration tab > Protocol Configuration menu >
1.
Trunk/IP Group submenu > Account Table page item).
To add an Account, in the 'Add' field, enter the desired table row index, and then click
2.
Add. A new row appears.
Configure the Account parameters according to the table below.
3.
Click the Apply button to save your changes.
4.
To save the changes, refer to ''Saving Configuration'' on page 230.
5.
Note:
Parameter
Served Trunk
Group
Served IP Group
Serving IP Group
Version 5.6
You can also configure the Account table using the ini file table parameter
Account (refer to ''SIP Configuration Parameters'' on page 284).
Figure 3-85: Account Table Page
For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' on page 30.
Table 3-52: Account Parameters Description
The Trunk Group ID for which the device performs registration and/or
authentication to a destination IP Group (i.e., Serving IP Group).
For Tel-to-IP calls, the Served Trunk Group is the source Trunk Group from
where the call initiated. For IP-to-Tel calls, the Served Trunk Group is the
'Trunk Group ID' defined in the 'IP to Trunk Group Routing' table (refer to ''IP to
Trunk Group Routing'' on page 181). For defining Trunk Groups, refer to
"Configuring the Trunk Group Table" on page
Note: For IP-to-IP call routing, this parameter must be set to -1 (i.e., no trunk).
The Source IP Group (e.g., IP-PBX) for which registration and/or authentication
is performed.
The destination IP Group ID (defined in ''Configuring the IP Groups'' on page
201) to where the REGISTER requests (if enabled) are sent or Authentication
is performed. The actual destination to where the REGISTER requests are sent
is the IP address defined for the Proxy Set ID (refer to ''Proxy Sets Table'' on
page 141) associated with this IP Group. This occurs only in the following
conditions:
The parameter 'Registration Mode' is set to 'Per Account' in the 'Trunk
Group Settings' table (refer to ''Configuring the Trunk Group Settings'' on
page 197).
Description
195
205
3. Web-Based Management
.
November 2008
Advertisement
Table of Contents
