AudioCodes Mediant 2000 User Manual page 329

SIP User's Manual
Parameter
EnableStandardSIDPayloadT
ype
ComfortNoiseNegotiation
RTPSIDCoeffNum
DTMFVolume
DTMFGenerationTwist
DTMFInterDigitInterval
DTMFDigitLength
RxDTMFHangOverTime
TxDTMFHangOverTime
DTMFTransportType
RFC2833PayloadType
R1DetectionStandard
UserDefinedToneDetectorEn
able
UDTDetectorFrequencyDevia
tion
CPTDetectorFrequencyDevia
tion
Version 5.6
For a description of this parameter, refer to ''Configuring the RTP /
RTCP Settings'' on page 71.
For a description of this parameter, refer to ''Configuring the RTP /
RTCP Settings'' on page 71.
Determines the number of spectral coefficients added to an SID
packet being sent according to RFC 3389. Valid only if
EnableStandardSIDPayloadType is set to 1.
The valid values are [0] (default), [4], [6], [8] and [10].
For a description of this parameter, refer to ''Configuring the Voice
Settings'' on page 66.
For a description of this parameter, refer to ''Configuring the Voice
Settings'' on page 66.
Time in msec between generated DTMF digits to PSTN side (if
TxDTMFOption = 1, 2 or 3).
The default value is 100 msec. The valid range is 0 to 32767.
Time (in msec) for generating DTMF tones to the PSTN side (if
TxDTMFOption = 1, 2 or 3). It also configures the duration that is
sent in INFO (Cisco) messages.
The valid range is 0 to 32767. The default value is 100.
Defines the Voice Silence time (in msec units) after playing DTMF
or MF digits to the Tel / PSTN side that arrive as Relay from the IP
side.
Valid range is 0 to 2,000 msec. The default is 1,000 msec.
Defines the Voice Silence time (in msec) after detecting the end of
DTMF or MF digits at the Tel / PSTN side when the DTMF
Transport Type is either Relay or Mute.
Valid range is 0 to 2,000 msec. The default is 1,000 msec.
For a description of this parameter, refer to ''Configuring the Voice
Settings'' on page 66.
For a description of this parameter, refer to ''DTMF & Dialing
Parameters'' on page 147.
Determines the R1 MF protocol used for detection.
[0] = ITU (default)
[1] = R1.5
Enables or disables detection of User Defined Tones signaling.
[0] = Disable
[1] = Enable
Defines the deviation (in Hz) allowed for the detection of each
signal frequency.
The valid range is 1 to 50. The default value is 50.
Defines the deviation (in Hz) allowed for the detection of each CPT
signal frequency.
The valid range is 1 to 30. The default value is 10.
329
4. ini File Configuration
Description
November 2008