Figure 3-93: Snmp V3 Setting; Table 3-59: Snmp Community Strings Parameters Description - AudioCodes Mediant 2000 User Manual

SIP User's Manual

Table 3-59: SNMP Community Strings Parameters Description

Parameter
Community String
Trap Community String
[SNMPTrapCommunityString]
3.5.1.1.3 Configuring SNMP V3 Users
The 'SNMP V3 Settings' page allows you to configure authentication and privacy for up to
10 SNMP v3 users.
To configure the SNMP v3 users, take the following 6 steps:
Access the 'Management Settings' page, as described in ''Configuring the
1.
Management Settings'' on page 220.
In the 'SNMP V3 Table' field, click the right-pointing arrow
2.
Settings' page appears.
To add an SNMP v3 user, in the 'Add' field, enter the desired row index, and then click
3.
Add. A new row appears.
Configure the SNMP V3 Setting parameters according to the table below.
4.
Click the Apply button to save your changes.
5.
To save the changes, refer to ''Saving Configuration'' on page 230.
6.
Notes:
Version 5.6
Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
Read / Write [SNMPReadWriteCommunityString_x]: Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
Figure 3-93: SNMP V3 Setting Page
•
For a description of the web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' on page 30.
•
You can also configure SNMP v3 users using the ini file table parameter
SNMPUsers (refer to ''SNMP Parameters'' on page 282).
Description
225
3. Web-Based Management
button; the 'SNMP V3
November 2008