Emergency Notice - Icom VE-PG2 Instruction Manual

3-11 E����g����� ��������
ï E����g����� �������� ���������g
Set the emergency notice output ports when the audio signal is input to the [IN]
port or calling to setting port which is set at �IP network connection setting�� in the
�Emergency notice�� on the �Connection setting–IP network connection.��
Place the mouse pointer on �Connection setting,�� and then click �Emergency notice
shown on the list.
q
w
e
r
t
q T��������v��� 1 (TRX1)
If you click the �Transceiver 1 (TRX1)�� check box, the VE-PG2 sends the emergency
notice to the [TRX1] port.
(Default: o Transceiver 1 (TRX1))
w T��������v��� 2 (TRX2)
If you click the �Transceiver 2 (TRX2)�� check box, the VE-PG2 sends the emergency
notice to the [TRX2] port.
(Default: o Transceiver 2 (TRX2))
e T��������v��� 3 (TRX3)
If you click the �Transceiver 3 (TRX3)�� check box, the VE-PG2 sends the emergency
notice to the [TRX3] port.
(Default: o Transceiver 3 (TRX3))
r EXT Ou���u��
If you click the �EXT Output�� check box, the VE-PG2 sends the emergency notice to
the external device which is connected to the [OUT] port.
(Default: o EXT Output)
• This is not displayed when �Combined mode�� is selected in �EXT I/O port mode setting.��
t E����g����� �������� ��qu��������
If you click the �Emergency notice equipment�� check box, the VE-PG2 sends the
emergency notice to the transceiver or external device that is connected to the
VE-PG2.
(Default: o Emergency notice equipment)
• The device can be set by the �IP Communication setting�� in �IP Communication–Emergency
notice.��
• You can transmit or send the emergency notice only when �Emergency�� is set at the �Input
connection port�� in �TRX/EXT–EXT Input(EXT IN).��
VE-PG2 SETTING SCREEN
�Connection setting,�� and then click �Emergency notice Connection setting,�� and then click �Emergency notice ,�� and then click �Emergency notice �� and then click �Emergency notice then click �Emergency notice click �Emergency notice �Emergency notice��
3
1
2
3
4
5
6
7
8
9
10
11
87