M Ext Control Terminal - Icom VE-PG3 Instruction Manual

5
BRIDGE MODE SETTING SCREEN
8. [Port Settings] Menu (continued)

M EXT Control Terminal

Set the details of the control signal from the [EXT1]/[EXT2] port.
Note: Appears only when "Voice Data Detection" is selected in [Valid Timing].
q Input Type .....................
w Event ON Time ...............
[EXT2] port
[Port Settings]–[EXT Input 1 (EXT1)/EXT Input 2 (EXT2)]
Select the control signal input condition.
• Momentary
While the control signal is input from the B3/B4 terminal (General control
I/O), activates the port.
• One-shot
When the control signal is input from the B3/B4 terminal (General control
I/O), continuously activates the port. And deactivates with no input.
Select the delay time until the input is detected.
Range: [0.1], [0.3], [0.5], [1], [1.5], [2], [3] (second)
A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4 A1~A4 A1~A4
A1~A4 A1~A4 B1~B4 B1~B4 C1~C4 C1~C4 A1~A4 A1~A4
VE-PG3 (Rear view)
• See Section 8 for port details.
5-89
B1~B4 B1~B4 C1~C4 C1~C4
B1~B4 B1~B4 C1~C4 C1~C4
(Default: Momentary)
(Default: 1)
[EXT1] port